Enable a Sensor as a Rule Trigger from the Sensor View in iMonnit

This feature allows you to quickly assign a sensor to an existing Rule what was previously created on the account. This method of setting trigger sensors allows you to easily view which Rule a sensor is set to trigger, and quickly enable multiple Rules from that sensor view.

Assigning the sensor as a trigger of an Rule from the sensor view

  • Log into the iMonnit Online Portal.
  • Select “Sensors” in the main navigation menu.
  • Select the card of the sensor you wish to add to existing Rules.
  • Select “Rules” (forked arrows icon) in the sub-navigation bar on the top of the page.

In the “Add Sensor to Existing Rule” pane toward the bottom of the window, all Rules which have been created on the account and are supported by that sensor will be displayed. There is a filter icon in the heading of this pane which will allow you to filter the Rule by name, type or the Rule to which the sensor has or has not already been assigned.

  • To enable a sensor as a trigger on a Rule, select the check mark icon next to the desired Rule.
    Sensors - Rule Trigger
    View Full Size

Note: It is good practice to be sure all the Rules for which you are adding trigger sensors are enabled.

Was this article helpful?